14 1791 999 11
CS350 Programming Functions
1. MAINTENANCE MENU
1.1 Engineer Log
1.1.1 Display Log
Use this function to consult the 40 event log
1.1.2 Clear Log
Will clear all events in the Engineer Log
1.2 Output Test
Use the [é ] and [ê ] keys to select the desired output. Use the [ü]
key to toggle the output polarity. Will return to its programmed status
when you move to the next output.
1.3 Show Open Zones
Will show any zone which is open. This is a useful test function.
1.4 Walk Test
Used to test individual inputs. Triggering the input will activate the
interior bell for 4 seconds,as well as latch and walk test outputs.
1.5 Led Test
This option will perform a sequential test of all keypad LED's
2. TIMERS
2.1 Entry Time
Programmable between 0 to 99 seconds.
2.2 Exit Time
Programmable between 0 to 99 seconds.
2.3 Split Entry Time
When this option is set and the entry time is exceeded, then only the
interior bells will sound. Only after the additional entry time expired,
which is half the time programmed in 2.1, will a full alarm be created.
2.4 Bell Times
2.4.1 Bell Cutout
Programmable between 0-99 minutes for exterior bell. When a
time limit is required for interior bell then see 2.4.3.
2.4.2 Bell Delay
Programmed delay in minutes for interior and exterior bells which
becomes operational only when the system is set and no digi
fault condition prevails (negative to terminal 20).
2.4.3 All Bells Cut
Select for ON if interior bell must be timed for duration of 'Bell Cutout'
time
Engineer Log
Output Test
Show open zones
Walk Test
Led Test
Entry Time
Exit Time
Split Entry Time
Bell Times
To Next Page
Loading...
Need help?
General
