14 1791 999 17
6.1.4 Armed Display On / Off
Determines if the display will show the armed status or time & date
when armed.
6.1.5 Exit Fault Buzzer/Bell
Deterines if the buzzer only or buzzer + interior bell will activate
with an exit fault.
6.1.6 Final Door On / Off
After introducing the code, the panel will arm 4s. after having opened
and closed the exit zone or access zone even before the exit time
has expired.
6.2 P.A. Menu
6.2.1 P.A. Silent/Bells
Programme if a PA alarm must be silent or loud.
6.2.2 PA,LF Silent/Bells
Programme if a PA alarm must be silent or loud when a phone line
fault is present.
6.2.3 éê PA On/Off
Programme if the keypad panic buttons are operational or not.
6.3 Partguard / Chime
6.3.1 Timed Partguard On/Off
Define if the panel is armed with or without exit time.
6.3.2 Access zones with Partguard
Define if an access zone becomes an entry/ exit zone when
partially armed or not.
6.3.3 Partguard Digi On/Off
Define if the alarm output operates when partially armed or not.
6.3.4 Latched Chime On/Off
If Latched Chime is set to On, the chime will remain operational
each time the system is disarmed untill manually canceled by user.
6.3.5 Interior Bell Chime On/Off
Define if the interior bell follows the chime function or not.
6.4 Engineer reset menu
Define the conditions which will call for an engineer reset. When
a panel asks for [Call Engineer nn], were nn is a number, the user
can't arm his panel.
6.4.1 Reset Code/FTC input or Code only
When made negative,Input 20 (Fail To Communicate or Digi Fault)
may be used to clear engineer reset. When only a code is allowed
to reset, programme for [Reset Code Only].
CS350 Programming Functions
Armd/Disarm Menu
P.A. Menu
Partguard/Chime
Engineer reset
To Next Page
Loading...
Need help?
General
