3-38
Chapter 3: BIOS setup
Chapter 3
3.6.5 USB Configuration
The items in this menu allow you to change the USB-related features.
The Mass Storage Devices item shows the auto-detected values. If no USB device is
detected, the item shows None.
Intel xHCI Mode [Smart Auto]
[Auto] The xHCI is automatically enabled and runs at USB 3.0 mode when the
xHCI driver is installed in the operating system.
[Smart Auto] Upon detection, the xHCI driver supports the USB 3.0 mode during both
POST and operating system.
[Enabled] Enables the xHCI controller.
[Disabled] Disables the xHCI controller.
xHCI Legacy USB Support [Enabled]
[Enabled] Your system supports the USB 3.0 devices in legacy operating systems.
[Disabled] Your USB 3.0 devices can be used for BIOS setup only and cannot be
recognized in the boot devices list.
[Auto] Your system automatically detects the presence of USB3.0 devices at
startup. If any USB 3.0 devices are detected, the xHCI legacy USB support
is enabled.
To Next Page
Loading...
Need help?
General
