64
14.3.1 Setting the weather compensation
To set up the weather compensation, follow the steps below.
1 Turn the selector wheel to highlight the Parameters Zone you want to set.
In this case Zone 1 Parameters.
Press OK.
2 Turn the selector wheel to highlight 4.7 Zone regulation Parameters.
Press OK.
3 Turn the selector wheel to highlight 4.7.0 Heating Type.
Press OK.
Make a choise between: 0 Underfoor or
1 Radiator or
or
3 Radiators (main) + underfoor or
4 Convector or
5 Air heating
Press BACK to the 4.7 Zone regulation Parameters screen.
4 Turn the selector wheel to highlight 4.7.2 Building Isolation Level.
Press OK.
Make a choise between: 0 Poor or
1 Average or
2 Good
Press BACK to the 4.7 Zone regulation Parameters screen.
5 Turn the selector wheel to highlight 4.7.3 Building Size.
Press OK.
Make a choise between: 0 Small or
1 Average or
2 Large
6 Turn the selector wheel to highlight .
Press OK.
7 Turn the selector wheel to set the Room Inuence 0 OFF.
To Next Page
Loading...
Need help?
General
