Atlas Copco STa 6000 User Manual

System Overview STa 6000 User Guide
36 (324) 9836 8243 01 Edition 3.1
2.3.5 Battery
STa 6000 can operate powered by its battery pack or by the external power supply.
When the battery is not used, install the original cover supplied with the STa 6000.
To install the battery, turn off the STa 6000, remove the cover and then install the battery.
To replace a battery, switch off the STa 6000, remove the battery and install the new one.
NOTE: Refer to the Maintenance for important notes about how to keep battery in
a good working order.
2.3.5.1 Battery Charger
The battery can be charged either when installed in the STa 6000 (by the external power supply) or with
the specific battery charger. The battery charger is the same used for the STwrench. The specific adapter
to connect the STa 6000 battery is required.
Battery charger
Adapter
Controller
Battery
1. Remove the cover
2. Insert this side first

Atlas Copco STa 6000 Specifications

General

Brand	Atlas Copco
Model	STa 6000
Category	Measuring Instruments
Language	English