16
Preparation
Removing/Inserting the Bobbin
Removing the Bobbin
► open bobbin cover, the hook system swings to the front
► push the latch in the center of the bobbin to the left, the
bobbin pops out and can be removed
Inserting the Bobbin
► with bobbin markings facing the front, place the bobbin
into the hook and push until it clicks into place
Threading Lower Thread
► pull the thread to the right into slit A, then left under the
spring
► pull thread over thread cutter B and cut
► close the bobbin cover slowly, the hook swings back to
the rear
A
B
Only remove the bobbin if the hook is at
the end position (threading position).
It is not necessary to bring the bobbin thread
up through the hole in the stitch plate as the
loose end is just the right length to start sewing.
Check the threading path
After threading the hook, hold the mirror under the
swung-out hook unit as shown in the pictures below.
► Position of bobbin thread when threaded for sewing
To Next Page
Loading...
Need help?
General
