BMW 2013 F800GT User Manual

Removing front wheel
Make sure ground is level and
firm and park motorcycle.
Remove screw 1 and take
wheel speed sensor out of
bore.
Once the calipers have
been removed, there is
a risk of the brake pads being
pressed together to the extent
that they cannot be slipped back
over the brake rotor on reassem-
bly.
Do not operate the handbrake
lever when the brake calipers
have been removed.
Remove screws 1 of brake
calipers on left and right.
Push brake pads 1 slightly
apart by turning the brake
caliper 2 back and forth against
the brake rotor 3.
Mask off area of wheel rim that
could be scratched in process
of removing brake calipers.
Carefully pull brake calipers
back to remove them from the
brake rotors.
Place motorcycle on an auxil-
iary stand; BMW Motorrad rec-
ommends BMW Motorrad rear-
wheel stand.
Mount rear-wheel stands
( 87).
7
82
z Maintenance

BMW 2013 F800GT Specifications

General

Bore x Stroke	82 mm x 75.6 mm
Compression Ratio	12.0:1
Transmission	6-speed
Front Suspension	Telescopic fork, 43 mm
Rear Brakes	Single disc brake, diameter 265 mm, single-piston floating caliper
Power	90 hp (66 kW) @ 8, 000 rpm
Torque	86 Nm at 5, 800 rpm
Rear Suspension	Cast aluminum dual swing arm, central spring strut
Front Brakes	Double disc brake, diameter 320 mm, 4-piston calipers
ABS	BMW Motorrad ABS
Seat Height	800 mm
Curb Weight	213 kg
Fuel Capacity	15 L (4.0 US gal)
Final Drive	Chain