BMW 2013 F800GT User Manual

Front wheel stand
Mounting front wheel
stand
The BMW Motorrad front
wheel stand is not designed
to support the motorcycle with-
out the assistance of an auxiliary
stand. A motorcycle standing on
the front wheel stand and the
rear wheel alone can fall over.
Place the motorcycle on an aux-
iliary stand before lifting the front
wheel with the BMW Motorrad
front-wheel stand.
Place motorcycle on an auxil-
iary stand; BMW Motorrad rec-
ommends BMW Motorrad rear-
wheel stand.
Mount rear-wheel stands
( 87).
with center stand
OE
Make sure ground is level and
firm and place motorcycle on
center stand.
Use basic stand with front
wheel mount. The basic stand
and its accessories are avail-
able through your authorized
BMW Motorrad retailer.
Loosen mounting screw 1.
Push the two mounts 2 far
enough apart that the tele-
scopic fork fits between them.
Use locating pins 3 to set front
wheel stand to desired height.
Center front wheel stand rela-
tive to front wheel and push it
against front axle.
Align the two mounts 2 so that
the telescopic fork rests se-
curely on them.
Tighten mounting screw 1.
7
86
z Maintenance

BMW 2013 F800GT Specifications

General

Bore x Stroke	82 mm x 75.6 mm
Compression Ratio	12.0:1
Transmission	6-speed
Front Suspension	Telescopic fork, 43 mm
Rear Brakes	Single disc brake, diameter 265 mm, single-piston floating caliper
Power	90 hp (66 kW) @ 8, 000 rpm
Torque	86 Nm at 5, 800 rpm
Rear Suspension	Cast aluminum dual swing arm, central spring strut
Front Brakes	Double disc brake, diameter 320 mm, 4-piston calipers
ABS	BMW Motorrad ABS
Seat Height	800 mm
Curb Weight	213 kg
Fuel Capacity	15 L (4.0 US gal)
Final Drive	Chain