Everything under control
80
3. Turn the controller until "Set time" is
selected and press the controller.
Adjusting settings
1. Turn the controller to set the hour and press
the controller.
2. Turn the controller to set the minutes and
press the controller.
The system accepts the new time.
Switching on hour signal*
Shortly before the hour, three signal tones will
be emitted.
Select "Hour memo" and press the controller.
The hour signal is switched on.
Setting the time format
1. Select "Time format" and press the control-
ler.
2. Select the desired format and press the
controller.
The setting is saved for the remote control cur-
rently in use.
Setting date
1. Select "Date" and press the controller.
2. Select "Set date" and press the controller.
The first part of the date setting is selected,
in this example the day.
3. Turn the controller to make the adjustment.
4. Press the controller to adopt the setting.
The next part of the time setting is selected.
5. Complete the setting. Once the setting has
been completed, the date is memorised.
Altering the date format
1. Select "Date format" and press the control-
ler.
2. Select the desired format and press the
controller.
The setting is saved for the remote control cur-
rently in use.
Brightness of the control display
The brightness is automatically adjusted to
ambient light conditions. However, you can
adjust the basic setting.
1. Select "Brightness" and press the control-
ler.
2. Move the controller to the right if necessary,
to call up "Display Offset".
3. Turn the controller until the desired setting
is obtained.
The setting is saved for the remote control cur-
rently in use.
To Next Page
Loading...
Need help?
General
