113
with Connectivity
OE
Warning signal: Set the in-
creasing and decreasing or in-
termittent alarm tone.
Tilt sensor: Activate tilt
sensor to monitor the inclina-
tion of the vehicle. The anti-
theft alarm is tripped if any at-
tempt is made to steal a wheel
or lift the vehicle for towing, for
example.
Deactivate the tilt sensor
when transporting the
vehicle in order to prevent the
DWA from tripping.
Arming tone: In addition to
turn indicators flashing, alarm
tone sounds as confirmation of
activation/deactivation of the
DWA.
Arm automatically: Auto-
matic activation of the alarm
function when the ignition is
switched off.
Default settings
The anti-theft alarm ships with
the following default settings:
Confirmation alarm tone after
having activated/deactivated
the DWA: no.
Alarm tone: intermittent.
TYRE PRESSURE CONTROL
(RDC)
with Connectivity
OE
with tyre pressure control
(RDC)
OE
with riding modes Pro
OE
Switching specified-pressure
warning on or off
The system can be set to
issue a specified-pressure
warning when tyre pressure
drops to the defined min-
imum.
Navigate to Settings,
Vehicle settings, RDC.
Switch Target pressure
warn. on or off.
HEATED HANDLEBAR GRIPS
with heated grips
OE
Operating heated handlebar
grips
Start the engine ( 155).
The heating in the heated
handlebar grips can be
activated only when the engine
is running.
The increase in power
consumption caused by
having the heated handlebar
grips switched on can drain the
battery if you are riding at low
engine speeds. If the charge
level is low, the heated handle-
bar grips are switched off to
To Next Page
Loading...
Need help?
General
