212 MAINTENANCE
Insert right adjustment
plate 4.
Install washer 3 and axle
nut 2, but do not tighten yet.
without centre stand
OE
Remove the auxiliary stand.
Insert the wheel speed sensor
into the bore and tighten
screw 1 to the specified
torque.
Wheel-speed sensor,
rear, to brake caliper
carrier
Thread-locking compound:
micro-encapsulated
8 Nm
WARNING
Brake pads not lying against
the brake disc
Risk of accident due to
delayed braking effect.
Before driving, check that
the brakes respond without
delay.
After completing work, op-
erate the brake several times
until the brake pads are bed-
ded.
Check the chain tension
( 213).
Adjust the chain tension
( 213).
CHAIN
Lubricating chain
ATTENTION
Inadequate cleaning and lub-
rication of the drive chain
Accelerated wear
Clean and lubricate the drive
chain at regular intervals.
Lubricate the drive chain
every third fuel stop.
Lubricate the chain more fre-
quently if the motorcycle is
ridden in wet, dusty or dirty
conditions.
To Next Page
Loading...
Need help?
General
