BMW R 1100 S User Manual

18
Maintenance and care
2
L Note:
When removing a front or rear
wheel, you are recommended
to use the auxiliary stand,
special tool No. 00 1 560,
which is available from your
BMW motorcycle dealer.
Attaching/removing the
auxiliary stand
e Attention:
Switch off the engine before
installing the stand.
Make sure that there is a firm
surface under the stand.
• Support the motorcycle on its
side stand
• Place auxiliary stand 3
beneath the motorcycle
–Knob1 on the left-hand
side of the motorcycle
• Pull out locking pin 2
• Pull out knob 1 and secure it
with locking pin 2
Auxiliary stand
1
3
2
20S02g7.fm Seite 18 Donnerstag, 24. Juni 2004 8:36 08

BMW R 1100 S Specifications

General

Displacement	1085 cc
Bore x Stroke	99 mm x 70.5 mm
Compression Ratio	10.3:1
Transmission	5-speed
Final Drive	Shaft drive
Fuel System	Electronic fuel injection
Rear Brakes	Single 276 mm disc, 2-piston caliper
Front Tyre	120/70 ZR 17
Rear Tyre	170/60 ZR 17
Wheelbase	1, 478 mm
Fuel Capacity	18 liters
Engine Type	Air/oil-cooled, 4-stroke, flat twin
Power	98 hp @ 7, 500 rpm
Front Suspension	Telelever
Rear Suspension	Paralever
Seat Height	810 mm
Front Brakes	Dual 305 mm discs, 4-piston calipers