BMW R 1100 S User Manual

67
Maintenance and care
2
Laying up
•Clean the motorcycle
(
b 63-66)
• Remove the battery
(
b 58-62)
• Spray the brake and clutch
lever pivots and the side
stand pivots with a suitable
lubricant
• Coat bright metal/chrome-
plated parts with an acid-free
grease (e.g. Vaseline)
• Park the motorcycle out of
use in a dry place
• Place a support material
under the engine so that
neither wheel is carrying any
weight. If necessary, install
the auxiliary stand (
b 20)
• When placing the support
material in position, avoid
damage to the exhaust pipes.
L Note:
Before laying the vehicle up out
of use have the engine oil and
the oil filter element changed by
a specialist workshop, prefera-
bly your authorised BMW
motorcycle dealer.
It is always a good idea to com-
bine the preparations for a lay-
up and the post lay-up work
with a service check or inspec-
tion by a specialist workshop,
preferably your authorised
BMW motorcycle dealer.
Laying up the motorcycle
20sbkg7.book Seite 67 Mittwoch, 2. Juni 2004 8:58 08

BMW R 1100 S Specifications

General

Displacement	1085 cc
Bore x Stroke	99 mm x 70.5 mm
Compression Ratio	10.3:1
Transmission	5-speed
Final Drive	Shaft drive
Fuel System	Electronic fuel injection
Rear Brakes	Single 276 mm disc, 2-piston caliper
Front Tyre	120/70 ZR 17
Rear Tyre	170/60 ZR 17
Wheelbase	1, 478 mm
Fuel Capacity	18 liters
Engine Type	Air/oil-cooled, 4-stroke, flat twin
Power	98 hp @ 7, 500 rpm
Front Suspension	Telelever
Rear Suspension	Paralever
Seat Height	810 mm
Front Brakes	Dual 305 mm discs, 4-piston calipers