BMW R 1100 S User Manual

45
Maintenance and care
2
1
2
Parking light
e Attention:
Switch off the ignition before
changing a bulb.
L Note:
Do not touch the glass of new
bulbs with the fingers.
Use a clean, dry cloth to hold
the bulbs when inserting them.
• Make sure the ground is level
and firm and lift the motor-
cycle onto its side stand
• Turn the handlebars to the left
• Take off the left rubber cover
• Release the bulb holder 1 by
turning to the right, and pull
it out
• Remove the bulb 2 from the
bulb holder
• Installation is the reverse of
the removal procedure; when
inserted and turned to the left
the bulb holder 1 must be
heard to engage in its
mounting
– Parking light bulb: 12 V 5 W
Changing bulbs
20sbkg7.book Seite 45 Mittwoch, 2. Juni 2004 8:58 08

BMW R 1100 S Specifications

General

Displacement	1085 cc
Bore x Stroke	99 mm x 70.5 mm
Compression Ratio	10.3:1
Transmission	5-speed
Final Drive	Shaft drive
Fuel System	Electronic fuel injection
Rear Brakes	Single 276 mm disc, 2-piston caliper
Front Tyre	120/70 ZR 17
Rear Tyre	170/60 ZR 17
Wheelbase	1, 478 mm
Fuel Capacity	18 liters
Engine Type	Air/oil-cooled, 4-stroke, flat twin
Power	98 hp @ 7, 500 rpm
Front Suspension	Telelever
Rear Suspension	Paralever
Seat Height	810 mm
Front Brakes	Dual 305 mm discs, 4-piston calipers