EasyManuals Logo
Home>Bosch>Security System>Security Systems

Bosch Security Systems User Manual

Bosch Security Systems
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
41
WW
WW
W
ALK TESALK TES
ALK TESALK TES
ALK TES
T ?T ?
T ?T ?
T ?
COMMAND 4 4COMMAND 4 4
COMMAND 4 4COMMAND 4 4
COMMAND 4 4
WW
WW
W
alk Talk T
alk Talk T
alk T
ee
ee
e
ss
ss
s
tt
tt
t
DescriptionDescription
DescriptionDescription
Description
Use this function to test command centers, detection
devices, and sounders (both interior and exterior) to
be certain they function properly. You can review
untested points at the command center to help pin-
point any problems.
You cannot arm the system while in the walk test mode,
and no alarm reports are sent to the security company
unless a 24-hour point is activated (such as fire or
panic).
Beginning the walk test activates the burglary bell and
sounds the burglary bell at the command center for 2
seconds. The AC is disabled for 4 minutes in order to
test the system’s battery power. If the battery cannot
maintain the system for the 4 minute period, the
command center becomes unresponsive. If this
happens, contact your security company. At the end of
the 4 minute period, AC is returned to the system and
the panel restores. To test individual detection devices,
simply activate sensors and open protected doors and
windows one-at-a-time. As each detection device is
faulted, the Command Center emits a brief tone and
the display indicates for 60 seconds that the point has
been tested. This verifies that each detection device is
working properly.
Using WUsing W
Using WUsing W
Using W
alk Talk T
alk Talk T
alk T
ee
ee
e
ss
ss
s
tt
tt
t:
1. Ensure the display shows idle disarmed text.
2. Press the
COMMAND COMMAND
COMMAND COMMAND
COMMAND bar. The display shows
SYSTEM COMMANDSYSTEM COMMAND
SYSTEM COMMANDSYSTEM COMMAND
SYSTEM COMMAND.
3. Press the
4 4
4 4
4 key, followed by the
44
44
4 key.
Note:Note:
Note:Note:
Note: The Command Menu may be used in place of
steps 2 and 3 to initiate this function. Press
the
MENU MENU
MENU MENU
MENU key to enter the Command Menu,
then press
NEXT NEXT
NEXT NEXT
NEXT repeatedly until the
WALKWALK
WALKWALK
WALK
TEST ?TEST ?
TEST ?TEST ?
TEST ? prompt is reached. Press
ENTENT
ENTENT
ENT.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bosch Security Systems and is the answer not in the manual?

Bosch Security Systems Specifications

General IconGeneral
BrandBosch
ModelSecurity Systems
CategorySecurity System
LanguageEnglish

Related product manuals