EasyManuals Logo
Home>Bosch>Security System>Security Systems

Bosch Security Systems User Manual

Bosch Security Systems
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
43
3. Press the
4 4
4 4
4 key followed by the
77
77
7 key.
Note:Note:
Note:Note:
Note: If you prefer, you may use the Command Menu
in place of steps 2 and 3 to initiate this
function. Press the
MENU MENU
MENU MENU
MENU key to enter the
Command Menu, then press
NEXT NEXT
NEXT NEXT
NEXT repeatedly
until you reach the
RESET SENSORS ?RESET SENSORS ?
RESET SENSORS ?RESET SENSORS ?
RESET SENSORS ?
prompt. Press
ENTENT
ENTENT
ENT.
4. The display shows
SENSORS RESETING SENSORS RESETING
SENSORS RESETING SENSORS RESETING
SENSORS RESETING for
approximately 3 seconds and then goes blank
before returning to idle disarmed text.
If you enter this function and the detector or sensor
resets momentarily, but then returns to a faulted
condition, the conditions causing the activation may
still be present or the detector may be faulty. Check to
be certain that there is no smoke, fire, or other danger
present.
If you can’t reset the detector or sensor contact your
security company.
RESET SENSORS ?RESET SENSORS ?
RESET SENSORS ?RESET SENSORS ?
RESET SENSORS ?
COMMAND 4 7COMMAND 4 7
COMMAND 4 7COMMAND 4 7
COMMAND 4 7
Reset SensorsReset Sensors
Reset SensorsReset Sensors
Reset Sensors
DescriptionDescription
DescriptionDescription
Description
Detection devices, such as smoke detectors and shock
sensors, must be reset after being activated. This
function momentarily removes power from these
sensors to reset them. It also clears point information
from the display, leaving the
ALARM SILENCEDALARM SILENCED
ALARM SILENCEDALARM SILENCED
ALARM SILENCED
message in the display as a reminder that the View
Memory function can be used to view the cleared point
information. Entering a valid passcode and then
pressing the
ESCESC
ESCESC
ESC key clears the
ALARM SILENCEDALARM SILENCED
ALARM SILENCEDALARM SILENCED
ALARM SILENCED
message and the event memory. Arming the system also
clears the display and the event memory.
Using Reset SensorsUsing Reset Sensors
Using Reset SensorsUsing Reset Sensors
Using Reset Sensors:
1. Ensure that the display is at idle disarmed text.
2. Press the
COMMANDCOMMAND
COMMANDCOMMAND
COMMAND bar. The display shows
SYSTEM COMMANDSYSTEM COMMAND
SYSTEM COMMANDSYSTEM COMMAND
SYSTEM COMMAND.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bosch Security Systems and is the answer not in the manual?

Bosch Security Systems Specifications

General IconGeneral
BrandBosch
ModelSecurity Systems
CategorySecurity System
LanguageEnglish

Related product manuals