B. Appendix (For Europe and Other Countries)
Important information: Regulations
Radio interference (220 to 240 volt model only)
This printer follows EN55022 (ClSPR Publication 22)/Class B.
Before you use this product, make sure that you use one of the following interface cables.
1 A shielded parallel interface cable with twisted-pair conductors and that it is marked IEEE 1284 compliant.
2 A USB cable.
The cable must not be more than 2 meters long.
IEC 60825-1 specification (220 to 240 volt model only)
This printer is a Class 1 laser product as defined in IEC 60825-1 specifications. The label shown below is
attached in countries where it is needed.
This printer has a Class 3B laser diode which produces invisible laser radiation in the laser unit. You should
not open the laser unit under any circumstances.
O1 Caution
Use of controls or adjustments or performance of procedures other than those specified in this User's Guide
may result in hazardous radiation exposure.
For Finland and Sweden
LUOKAN 1 LASERLAITE
KLASS 1 LASER APPARAT
O Varoitus!
Laitteen ktiytttiminen muutla kuin ttissti k_iytt5ohjeessa mainitulla tavatla saattaa altistaa ktiytttij_in
turvallisuusluokan 1 ylitttivtille ntikym_ittOm_ille laserstiteilytle.
_]_Varning
Om apparaten anvtinds p& annat stitt tin i denna Bruksanvisning specificerats, kan anvtindaren utstittas for
osynlig laserstr&lning, som Overskrider grtinsen f6r laserklass 1.
To Next Page
Loading...
Need help?
General
