7, Troubleshooting
Paper handling
First, make sure that you are using paper that meets Brother recommended paper specifications. See About
paper on page 5.
i
The printer does not feed • If there is paper in the paper tray, make sure it is straight. If the paper is curled,
paper, straighten it before printing. Sometimes it is helpful to remove the paper. Turn the
m
The printer does not feed paper
from the MP tray.
The printer does not feed m
envelopes.
A paper jam has occurred.
The printer does not print, m
m
When printing on normal paper, m
it creases.
When printing on Legal size
paper or longer sized paper,
the paper slides off the top
output tray.
stack over and put it back in the paper tray.
Cut the amount of paper in the paper tray, and then try again.
Make sure that manual feed mode is not chosen in the printer driver.
Fan the paper well and put it back in firmly.
Make sure that you have chosen the MP Tray in the Paper Source of the printer
driver.
The printer can feed envelopes from the multi-purpose tray. You must set up your
application to print on the size of envelopes you are using. This is usually done in
the page setup or document setup menu of your software. See your application
manual.
Clear the jammed paper. See Paper jams and how to clear them on page 84.
Make sure that the cable is connected to the printer.
Make sure that you have chosen the proper printer driver.
Change the printer driver setting in Media Type to a thin setting.
Pull out and lift up the output tray support flap.
83i
To Next Page
Loading...
Need help?
General
