65
TAPE MARGIN FUNCTION
The Tape margin function allows you to adjust the size of the margins on the left and right
sides of your text.
The default tape margin setting is FULL; however, three other settings are also available.
☞
After printing a label using the NONE tape margin setting, hold down and
press
once to feed the tape before pushing down on the tape cutter lever
to cut it. Otherwise some of the printed characters may be cut off.
After printing using the NARROW and HALF tape margin settings, push down on
the tape cutter lever to cut off the label, then use scissors to cut along the cutting
guide (:) to centre the text within the label.
To change the tape margin setting:
1 While holding down , press once, and keep held down to dis-
play the current tape margin setting.
2 While still holding down , continue pressing until the desired tape
margin setting is displayed.
3 Release to apply the selected tape margin setting to the entire text.
FULL
(25 mm
margins)
NONE
(no margins)
NARROW
(4 mm
margins)
HALF
(12 mm
margins)
To Next Page
Loading...
Need help?
General
