29
For Macintosh users
1
Insert the installer CD-ROM
into your CD-ROM drive.
2
Double-click the Wireless
Device Setup Wizard icon
in the Utilities folder.
3
When using "Method 1:
Configuration using the
Installer CD-ROM and
temporarily using a USB
cable", choose Yes, I have
a USB cable to use for
installation, and then click
[Next]. Go to 4-1.
When using "Method 2: One
push configuration using
WPS and configuration
using the Installer CD-
ROM", choose No, I do not
have a USB cable, and
then click [Next]. Go to 4-2.
If the Important Notice
screen appears, read the
notice. Check the box after
you confirm the SSID and
Network Key, and then click
[Next]/[Finish].
Go to
4-1. Go to 4-2.
For Method 1 users
4-1
Temporarily connect the
USB cable directly to the
computer and the printer,
and then click [Next].
5-1
The wizard will search for
wireless networks available
from your printer. Choose
the SSID that you noted in
MEMO Î page 21 and then
click [Next].
• If the list is blank, check that
the access point is turned on
and is broadcasting the
SSID, and then see if the
printer and the access point
are within range for wireless
communication.
Then, click [Refresh].
• If your access point is set to
not broadcast the SSID, you
can enter the SSID manually
by clicking the [Advanced]
button. Follow the on-screen
instructions for entering the
Name (SSID), and then click
[Next].
To Next Page
Loading...
Need help?
General
Weight and Dimensions
