Changing the Printer Settings
39
3
Menu Bar 3
1 Apply Settings to the Printer
Applies the settings to the printer.
2 Save Settings in Command File
Saves the specified settings in a command file. The file extension is .bin.
The saved command file can be used with the mass storage mode to apply the settings to a printer. (See
Mass Storage Mode on page 72.)
If the [Disable these settings] check box is selected, the settings in that tab are not saved.
• The following information is not saved with the command file:
• Node name
• IP address, subnet mask and default gateway (when the IP address is set to [STATIC])
• The saved communication settings commands are intended to be used only for applying settings to a
printer. To apply the settings to the printer using this command file, use the mass storage mode.
• Saved command files contain authentication keys and passwords. Take necessary measures to protect
saved command files, for example, save them in a location that cannot be accessed by other users.
• Do not send the command file to a different printer model.
5
9
10
6
1
2
3
4
7
8
To Next Page
Loading...
Need help?
General