Configuring the Printer's NetWare Network Settings
Follow the steps below to configure the NetWare network settings.
1. Start the web browser and enter the following URL in the Location (or Address ) box to display the RemoteUI
page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
2. Select Administrator Mode and click Logon.
3. If a password has been set on the printer, enter the password.
4. Click Network in the Device Manager menu at left to display the Network page.
5. Click Edit in the upper-right corner of the NetWare group to display the Edit NetWare Protocol Settings page.
6. Refer to the NetWare Settings Items table to complete the settings.
NetWare Settings Items
Item Details
Default
Setting
Frame Type Specify the type of frame to use in NetWare. Disabled
NCP Burst Mode Activate this setting to use NCP Burst Mode.
This mode supports fast data transfer when printing in queue server
mode. Normally, leave the setting On.
On
Print Application Choose the print service.
• Bindery PServer
• RPrinter
• NDS PServer
• NPrinter
NDS PSer-
ver
Packet Signature Select If Requested by Server to use packet signature. If Reques-
ted by
Server
Bindery
PServer
File Server Name Specify the name of a file server that has a NetWare print server.
(0–47 characters)
—
Print Server
Name
Specify the name of a NetWare print server.
(0–47 characters)
—
Print Server
Password
Set a password for the print server.
(0–20 characters)
—
Polling Interval Specify the interval to confirm jobs.
(1–15 seconds)
5
RPrinter Print Server
Name
Specify the name of a NetWare print server.
(0–47 characters)
—
Printer Number Specify the number of the printer connected to the NetWare print
server.
(0–15)
0
Network Setting
>
Network Setting (Windows)
>
iPF6300 Configuring the Printer's NetWare Network Settings
9
881
To Next Page
Loading...
Need help?
General