33
Basic Functions
Playback
E
Adjusting the Volume
When you use the LCD screen for playback, the camcorder plays back the sound via
built-in speaker. The speaker does not sound when you close the LCD panel. Use
headphones when using the viewfinder.
When Using Headphones
The headphones terminal also serves as AV terminal. Headphones can only be used
when “ ” is displayed on the screen. If not, change the setting following the procedure
below.
Open the menu and select [VCR SETUP]. Select [AV/PHONES ], set it to
[PHONES ] and close the menu.
The speaker does not sound when “ ” is displayed.
Do not connect headphones unless “ ” is displayed as it produces noise.
Adjusting the Volume
Turn the SET dial up to increase the volume, and down
to lower the volume.
• A volume bar appears for 2 seconds.
• You can turn off the volume completely by turning the SET dial
down until [OFF] appears. Turn the SET dial up to increase the
volume again.
CAMERA
PLAY (VCR) CARD CAMERA CARD PLAY
MENU
(37)
VCR SETUP AV/PHONES
••
AV
CAMERA
PLAY (VCR)
CARD CAMERA
CARD PLAY
SET dial
Speaker
(phones) terminal
To Next Page
Loading...
Need help?
General
