12
KEYPAD FUNCTIONS - MODELS 200 and 205, Cont.
ASTERISK, UNITS KEY
This combination will enter the Test mode. The Test mode is used to conduct a test of all
display elements. The test consists of 5 cycles, each lasting about one second:
1. All horizontal segments will turn on (no annunciators).
2. All vertical segments and decimal points will turn on (no annunciators).
3. All annunciators will turn on.
4. All display elements off.
5. The model number (205, 210) and the software version X.X.
6. The calibration numbers (C1 to C4).
ASTERISK, PRINT KEY
This combination is used to
change
the selected print ticket format. Pressing the
ASTERISK
then the
PRINT
key will display a prompt "Prt=". Press the
ENTER
key to
show the current value. If the setting displayed is acceptable, press the
ENTER
key
again to save it. Otherwise, press the
ASTERISK/
UP ARROW
key to "toggle" between the
different available values, then press the
ENTER
key to save it. Allowable values are:
0 = print tab settings 1 = Visual Print Format 1 2 = Visual Print Format 2
NOTE! When a print format is selected, it will remain active until changed by the
operator.
ANNUNCIATORS - MODELS 200 and 205
Annunciators are turned on to indicate that the display is in the mode corresponding to the
annunciator label or that the status indicated by the label is active. The annunciators flash on and
off to indicate that the 200/205 is waiting for an input from the keypad for the mode indicated by the
flashing annunciator.
ZERO
The ZERO annunciator indicates that the weight is within +/- 1/4 division of the center of zero.
STABLE
The STABLE annunciator is identified with two small triangle shapes and is turned on when the
weight display is stable. This means that the change in successive weight samples is less than the
motion limits selected during setup and calibration of the instrument.
NET
The NET annunciator is turned on to show that the displayed weight is the net weight (gross
weight less tare weight).
GROSS
The GROSS annunciator indicates that the displayed weight is the gross weight.
LO BAT -
Model 205 Only
The LO BAT annunciator is used with the battery operation and will turn ON to indicate that the
internal battery requires charging. If continued use further drains the battery, no change in
operation will occur until just before the battery voltage drops to a level where operation is affected.
At this level, the indicator will automatically turn itself off. Note that when the indicator is charging
the battery, the LO BAT annunciator will NOT be on.
T
The
T
(tons) annunciator is located to the right of the weight display and is turned on to show
that the displayed weight units is tons.
g
The
g
(gram)
annunciator is located to the right of the weight display and is used to indicate that
the displayed units of weight measurement is grams.
To Next Page
Loading...
Need help?
General
