32
ACCUMULATORS (ALL MODELS)
To
view
the NET accumulator:
1. Press the ASTERISK key then the NET/GROSS key.
2. Press the ASTERISK key to return to normal operation.
To
print
the NET accumulator:
1. Press the ASTERISK key, the NET/GROSS key, then the PRINT key
2. The indicator will return to normal operation when printing has been completed.
To
clear
(zero) the NET accumulator:
1. Press the ASTERISK key, the NET/GROSS key, then the ZERO key
2. Press the ASTERISK key to return to normal operation.
To
view
the Gross accumulator:
1. Press the ASTERISK key then the NET/GROSS key twice.
2. Press the ASTERISK key to return to normal operation.
To
print
the Gross accumulator:
1. Press the ASTERISK key, the NET/GROSS key twice, then the PRINT key
2. The indicator will return to normal operation when printing has been completed.
To
clear
(zero) the Gross accumulator:
1. Press the ASTERISK key, the NET/GROSS key twice, then the ZERO key
2. Press the ASTERISK key to return to normal operation.
BEFORE YOU CALL FOR SERVICE
The 200 Series Indicator has been designed to provide you with years of trouble-free operation. In
spite of this, troubles sometimes happen. Before calling for service assistance you should make
some initial checks to verify that a problem does exist. The following describes several types of
symptoms along with suggested remedies.
PROBLEM
POSSIBLE SOLUTIONS
Display does not turn on AC Operation:
Is the AC power cord fully inserted into the wall
receptacle? Check wall receptacle for proper AC power.
Try another electrical appliance in the same receptacle,
does it work? Check the circuit breaker. Has there been
power failure?
Battery operation: (
Models 205 and 210 only
) Check if
battery is installed and correctly. Is battery discharged -
replace or recharge.
Incorrect weight displayed Has the instrument been calibrated? Insure that the
scale platform isn't touching an adjacent object. Check
the load cell connector wiring. If using four (4) wire load
cells, insure the sense lead jumpers (J4 & J5) are
installed. Have proper operation procedures been
followed?
Indicator will not display weight Refer to Error Codes section and make certain that the
"oCAP" message is not displayed. If so, and scale is not
loaded, perform the calibration sequence.
To Next Page
Loading...
Need help?
General
