35
CALIBRATION SEAL INSTALLATION
If your 200 Series Weight Indicating Instrument is used in a commercial application it must be
tested and sealed by your local weights and measurements official. The 200 Series is designed to
accept a lead and wire security seal to prevent unauthorized access to the calibration adjustments.
Installation of this seal differs with the type of enclosure. Refer to the following figures for details
on the installation of these seals.
Model 200 = Figure No. 12 (
Figure No. 12 to be added at a later date
)
Models 205 and 210 = Figure No. 13
Figure No. 13
To Next Page
Loading...
Need help?
General
