Casio ALGEBRA FX 2.0 Plus User Manual

19990401
10-2-1
Connecting the Unit with a CASIO Label Printer
10-2 Connecting the Unit with a CASIO Label
Printer
After you connect the unit to a CASIO Label Printer with cable, you can use the Label Printer
to print screen shot data from the unit (see 10-6 Sending a Screen Shot). See the user’s
guide that comes with your Label Printer for details on how to perform this operation.
• The operation described above can be performed using the following Label Printer
models: KL-2000, KL-2700, KL-8200, KL-8700 (as of February 1999).
uTo connect the unit to a Label Printer
1. Check to make sure that the power of the unit and the Label Printer is off.
2. Connect the cable to the Label Printer.
3. Remove the cover from the connector of the unit.
4. Connect the other end of the cable to the unit.
5. Turn on the power of the unit, followed by the Label Printer.
•After you finish data communications, turn off power in the sequence: the unit first, and
then the Label Printer. Finally, disconnect the equipment.
Label Printer
Cable
#Be sure you keep the connector cover in a
safe place so you can replace it after you
finish your data communications.

Casio ALGEBRA FX 2.0 Plus Specifications

General

Type	Scientific
Cover	No
Form factor	Pocket
Control type	Buttons
Product color	Black
Digits	12 digits
Display type	Dot-matrix
Backlight color	Green
Backlight display	Yes
Display resolution	128 x 64 pixels
Display number of lines	8 lines
Display number of characters	21
RAM capacity	0.75 MB
ROM capacity	0.1406 MB
Storage media type	-
Battery type	CR2032, AAA
Power source	Battery
Number of batteries supported	5

Weight and Dimensions

Depth	178 mm
Width	82 mm
Height	19.5 mm
Weight	213 g