13
Quick Start Basics
A rechargeable lithium-ion battery (NP-80) is installed in the camera at the factory. Be
sure to charge the battery before trying to use the camera for the first time after
purchasing it. See page 109 for information about replacing the battery.
You can use either of the two following methods to charge the camera’s battery.
• USB-AC adaptor
• USB connection to a computer
. To charge with the USB-AC adaptor
While the camera is turned off, connect in the sequence shown below (
1
,
2
,
3
,
4
).
Charging time: Approximately 120 minutes
IMPORTANT!
• Make sure that you insert the cable connector into the USB/
AV port until you feel it click securely into place. Failure to
insert the connector fully can result in poor communication or
malfunction.
• Note that even while the connector is fully inserted, you still
will be able to see the metal part of the connector as shown in
the illustration.
First, charge the battery prior to use.
4
3
2
1
USB cable
(included with camera)
Making sure that the mark on the USB cable connector is
towards the monitor screen side, connect the cable to the camera.
[USB/AV] port
USB-AC adaptor
Power cord
To Next Page
Loading...
Need help?
General
