92
Other Settings (Set Up)
Procedure
[MENU] * “Set Up” Tab * Sounds
• Setting a volume level of 0 mutes output.
Procedure
[MENU] * “Set Up” Tab * Startup
Display the image you want to use as your startup image and then select “On”.
• The startup image does not appear when you turn on the camera by pressing
[p] (PLAY).
• You can specify a snapshot you recorded as the startup image, or you can use the
special startup image provided in the camera’s built-in memory.
• If you select an audio snapshot as the startup image, the audio will not play at
startup.
• Formatting built-in memory (page 98) will delete the current startup image setting.
Configuring Camera Sound Settings (Sounds)
Startup
Specifies the startup sound.
Sound 1 - 5: Built-in sounds (1 through 5)
Off: Sound off
Half Shutter
Shutter
Operation
Operation
Specifies the sound volume. This setting is also used as the
audio level during video output (page 67).
Play
Specifies the volume of movie and Audio Snapshot audio
output. This setting is also used as the audio level during
video output (page 67).
Configuring a Startup Image (Startup)
To Next Page
Loading...
Need help?
General
