176
EDITING IMAGES
6. Press [T] to perform the required cut
operation(s).
7. In response to the confirmation message that
appears, use [S] and [T] to select “Yes” and
then press [SET].
• To cancel movie editing, select “No” instead of “Yes” and
then press [SET]. This will return to the paused movie
playback screen.
• The selected cut operation will take considerable time to
complete. Wait until the “Busy... Please wait...” message
disappears from the monitor screen before performing
any operation on the camera. Note that a cut operation
can take a very long time if the movie being edited is long.
For this type of
cut operation:
Do this:
Cut
(To-Point Cut)
Select the point up to which you want
to cut and then press [T].
Cut
(From-Point Cut)
Select the point from which you want
to cut and then press [T].
Cut
(Point-To-Point
Cut)
1.Select the start point of the center
segment and then press [T].
2.Select the end point of the center
segment and then press [T].
To Next Page
Loading...
Need help?
General
