CHAPTER 2
Installing the Cisco 3504 Wireless Controller
This chapter describes how to install the Cisco 3504 Wireless Controller.
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each warning
to locate its translation in the translated safety warnings that accompanied this device. Statement 1071
Warning
SAVE THESE INSTRUCTIONS
•
Installation Guidelines and Safety Warnings, page 7
•
Unpacking and Inspecting the Controller, page 8
•
Package Contents, page 9
•
Requirements Tools and Information, page 9
•
Initial System Configuration Information, page 10
•
Configuring Management Interface, page 11
•
Choosing a Physical Location, page 12
•
Installing the Controller, page 13
Installation Guidelines and Safety Warnings
This section includes the basic installation guidelines and safety warning statements. Read this section before
you start the installation procedure. Translations of the warning statements appear in the RCSI guide on
Cisco.com.
•
The operating environment must be within the ranges listed in Environmental Specifications , on page
35.
•
Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent lighting
fixtures. Make sure that the cabling is safely away from other devices that might damage the cables.
Cisco 3504 Wireless Controller Installation Guide
7