Send document comments to nexus7k-docfeedback@cisco.com
4-18
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 4 Configuring Layer 3 Interfaces
Monitoring Layer 3 Interfaces
Monitoring Layer 3 Interfaces
Use the following commands to display Layer 3 statistics:
show interface loopback number description Displays the loopback interface description.
show interface loopback number status Displays the loopback interface administrative
status and protocol status.
show interface vlan number Displays the VLAN interface configuration,
status, and counters.
show interface vlan number brief Displays the VLAN interface operational status.
show interface vlan number description Displays the VLAN interface description.
show interface vlan number private-vlan
mapping
Displays the VLAN interface private VLAN
information.
show interface vlan number status Displays the VLAN interface administrative
status and protocol status.
Command Purpose
Command Purpose
load- interval {interval seconds {1 | 2 | 3}} Beginning with Cisco NX-OS Release 4.2(1) for
the Cisco Nexus 7000 Series devices, sets three
different sampling intervals to bit-rate and
packet-rate statistics. The range for VLAN
network interface is 60 to 300 seconds, and the
range for Layer interfaces is 30 to 300 seconds.
show interface ethernet slot/port counters Displays the Layer 3 interface statistics (unicast,
multicast, and broadcast).
show interface ethernet slot/port counters brief Displays the Layer 3 interface input and output
counters.
show interface ethernet slot/port counters
detailed [all]
Displays the Layer 3 interface statistics. You can
optionally include all 32-bit and 64-bit packet and
byte counters (including errors).
show interface ethernet slot/port counters
errors
Displays the Layer 3 interface input and output
errors.
show interface ethernet slot/port counters
snmp
Displays the Layer 3 interface counters reported
by SNMP MIBs. You cannot clear these counters.
show interface ethernet slot/port.number
counters
Displays the subinterface statistics (unicast,
multicast, and broadcast).
show interface port-channel channel-id.number
counters
Displays the port-channel subinterface statistics
(unicast, multicast, and broadcast).
show interface loopback number counters Displays the loopback interface input and output
counters (unicast, multicast, and broadcast).