Cisco 7206 - VXR Router User Manual

Send document comments to nexus7k-docfeedback@cisco.com
2-28
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 2 Configuring Basic Interface Parameters
Configuring the Basic Interface Parameters
switch(config-if)# link debounce time 0
switch(config-if)#
Configuring the Interface Speed and Duplex Mode
The interface speed and duplex mode are interrelated, so you should configure both of their parameters
at the same time.
To see which speeds and duplex modes you can configure together for Ethernet and management
interfaces, see Table 2-2 on page 2-4.
Note The interface speed that you specify can affect the duplex mode used for an interface, so you should set
the speed before setting the duplex mode. If you set the speed for autonegotiation, the duplex mode is
automatically set to be autonegotiated. If you specify 10- or 100-Mb/s speed, the port is automatically
configured to use half-duplex mode, but you can specify full-duplex mode instead. If you specify a speed
of 1000 Mb/s (1 Gb/s) or faster, full duplex is automatically used.
BEFORE YOU BEGIN
Make sure that the remote port has a speed setting that supports your changes for the local port. If you
want to set the local port to use a specific speed, you must set the remote port for the same speed or set
the local port to autonegotiate the speed.
SUMMARY STEPS
1. configure terminal
2. interface interface
3. speed {{10 | 100 | 1000 | {auto [10 100 [1000]]}} | {10000 | auto}}
4. duplex {full | half | auto}
5. show interface interface
6. exit
7. copy running-config startup-config

Cisco 7206 - VXR Router Specifications

General

Brand	Cisco
Model	7206 - VXR Router
Category	Network Router
Language	English