Cisco Catalyst 2960-XR User Manual

PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 4
Verifies your entries.
show authentication sessions interface interface-id
Example:
Switch# show authentication sessions interface
Step 5
gigabitethernet2/0/1
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 6
Setting the Switch-to-Client Frame-Retransmission Number
In addition to changing the switch-to-client retransmission time, you can change the number of times that the
switch sends an EAP-request/identity frame (assuming no response is received) to the client before restarting
the authentication process.
You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
Note
Beginning in privileged EXEC mode, follow these steps to set the switch-to-client frame-retransmission
number. This procedure is optional.
SUMMARY STEPS
1.
configure terminal
2.
interface interface-id
3.
dot1x max-reauth-req count
4.
end
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
262 OL-29434-01
Configuring IEEE 802.1x Port-Based Authentication
Setting the Switch-to-Client Frame-Retransmission Number

Cisco Catalyst 2960-XR Specifications

General

Brand	Cisco
Model	Catalyst 2960-XR
Category	Switch
Language	English