Appendix C Compliance Information and Translated Safety Warnings
European Directives
C-42
Catalyst 4900 Series Switch Installation Guide
78-18039-02
European Directives
Statement 287—Declaration of Conformity to R&TTE Directive
1999/5/EC for the European Community, Switzerland, Norway,
Iceland and Liechtenstein
An electrical conducting path shall exist between the product chassis and the
metal surface of the enclosure or rack in which it is mounted or to a grounding
conductor. Electrical continuity shall be provided by using thread-forming type
mounting screws that remove any paint or nonconductive coatings and establish
a metal-to-metal contact. Any paint or other nonconductive coatings shall be
removed on the surfaces between the mounting hardware and the enclosure or
rack. The surfaces shall be cleaned and an antioxidant applied before
installation.
The DC return connection to this system should remain Isolated from the system
frame and chassis (DC-I).
The nominal DC operating voltage is -48V DC.
English:
This equipment is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC.
[Bulgarian]:
[Czech]:
Dansk
[Danish]:
Dette udstyr er i overensstemmelse med de væsentlige krav og andre
relevante bestemmelser i Direktiv 1999/5/EF.
Table C-3 GR-1089 Installation and Caution Instructions (continued)
To Next Page
Loading...
Need help?
General