CHAPTER
4-1
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
4
Installing the VDS Internet Streamer
Software and Initially Configuring a CDE
This chapter describes the initial installation of the Cisco VDS Internet Streamer Release 3.x, and 4.x
software application suite, and the initial configuration of a CDE.
• Launching a New CDE for the First Time, page 4-1
• Re manufacturing a CDE, page 4-14
If you received a new CDE 205/220/250/420/460/475 go to the “Launching a New CDE for the First
Time” section on page 4-1.
If you received a new CDE280, go to the “Launching a CDE280 for the First Time” section on page 4-3.
If you need to re manufacture a CDE for any reason, go to the “Re manufacturing a CDE” section on
page 4-14, and then go to “Launching a New CDE for the First Time” section on page 4-1.
If you need to upgrade or downgrade the software version of a VDS-IS system running on a CDE, see
the “Software Upgrade” section in the Cisco Internet Streamer CDS Software Configuration Guide.
Note For the procedure on installing VQE software on the CDE250 2V0, see the “Installing VQE Release 3.6
Software” section of the Release Notes for Cisco CDA Visual Quality Experience Application, Release
3.6.
Launching a New CDE for the First Time
When you receive a new CDE, the VDS-IS software is preloaded and the initial configuration is
complete. Perform the following steps to launch your VDS-IS for the first time:
To launch a CDE280 for the first time, see “Launching a CDE280 for the First Time” section on
page 4-3.
Step 1 Connect the cables to the CDE (see the “Making Physical Connections” section on page 3-37).
Step 2 Power up the CDE.
Step 3 Connect a terminal server serial port to the console to run the setup utility.
To Next Page
Loading...
Need help?
General
