Cisco NCS 5508 User Manual

• 3/16-inch flat-blade screwdriver
• Tape measure and level
• ESD wrist strap or other grounding device
• Antistatic mat or antistatic foam
• A Torx T15 screwdriver, or the Torx T15 key to install adapters
• Grounding cable (6 AWG recommended), sized according to local and national installation requirements;
the required length depends on the proximity of the switch to proper grounding facilities
• Ground lug (1)
• Crimping tool large enough to accommodate the girth of the lug
• Wire-stripping tool
• (ANSI) Pair of 19-inch mounting brackets
• M4 screws to fix brackets (16)
• M4 screws to fix ground lug (2)
Rack Mount and Accessory Kits
Rack Mount Kit
Rack mount kit for the Cisco 5504 (NC55-5504-RMK), Cisco NCS 5508 (NC55-5508-RMK), or NCS 5516
(NC55-5516-RMK) chassis includes the following:
QuantityDescriptionIllustration
1 kit• 10-32 x 3/4-in. Phillips screws (20) and nuts (20)
• 12-24 x 3/4-in. Phillips screws (20)
• M6 x 19 mm Phillips screws (20)
• Adjustable bottom-support rails (2) – Supports
depth of 4-post rack from 24" ~ 34"
Extended Rack Mounting Kit
(NC55-5500-RMK-E ) contains
adjustable bottom-support rails (2)
that support depths of 4-post rack
from 32" ~ 42"
Note
Router Accessory Kit
Router accessory kit (NC55-5500-ACC-KIT) includes the following:
Hardware Installation Guide for Cisco NCS 5500 Series Modular Routers
22
Prepare for Installation
Rack Mount and Accessory Kits

Cisco NCS 5508 Specifications

General

Brand	Cisco
Model	NCS 5508
Category	Network Router
Language	English