Cisco SD208T-NA User Manual

Configuring Security
Configuring TCP/UDP Services
Cisco Small Business 200 Series Smart Switch Administration Guide 237
17
STEP 5 Click Apply, and the rule is added to the access profile.
Configuring TCP/UDP Services
The TCP/UDP Services page enables TCP or UDP-based services on the switch,
usually for security reasons.
The switch offers the following TCP/UDP services:
• HTTP—Enabled by factory default
• HTTPS—Enabled by factory default
The active TCP connections are also displayed in this window.
To configure TCP/UDP services:
STEP 1 Click Security > TCP/UDP Services. The TCP/UDP Services page is displayed.
STEP 2 Enable or disable the following TCP/UDP services on the displayed services.
• HTTP Service—Indicates whether the HTTP service is enabled or disabled.
• HTTPS Service—Indicates whether the HTTPS service is enabled or
disabled.
The TCP Service Table displays the following fields for each service:
• Service Name—Access method through which the switch is offering the
TCP service.
• Type—IP protocol the service uses.
• Local IP Address—Local IP address through which the switch is offering the
service.
• Local Port—Local TCP port through which the switch is offering the service.
• Remote IP Address—IP address of the remote device that is requesting the
service.
• Remote Port—TCP port of the remote device that is requesting the service.
• State—Status of the service.

Cisco SD208T-NA Specifications

General

Brand	Cisco
Model	SD208T-NA
Category	Switch
Language	English