Cisco WAP4410N - Small Business Wireless-N Access Point User Manual

4
WAP4410N Wireless-N Access Point with Power Over Internet 9
Connecting the WAP4410N Access Point
This chapter describes how to place and connect the WAP4410N Access Point to
your network.
Depending on your application, you might want to set up the device first before
mounting it.
Placement Options
You can place the WAP4410N Access Point horizontally on its rubber feet,
vertically in a stand, or mount it on the wall.
Desktop Option
For desktop mounting, place the access point horizontally on a surface so it sits on
its four rubber feet.
Wall-Mount Option
To mount the WAP4410N Access Point on a wall, follow these steps.
STEP1 Determine where you want to mount the WAP4410N Access Point and install two
screws (not supplied) that are 2-15/16 inches apart (approximately 7.46 cm.).
STEP 2 With the back panel pointing up (if installing vertically), line up the WAP4410N
Access Point so that the wall-mount crisscross slots on the bottom of the access
point line up with the two screws.

Cisco WAP4410N - Small Business Wireless-N Access Point Specifications

General

Brand	Cisco
Model	WAP4410N - Small Business Wireless-N Access Point
Category	Wireless Access Point
Language	English