Cisco WAP4410N - Small Business Wireless-N Access Point User Manual

Configuring the WAP4410N Wireless-N Access Point
Configuring Status Settings
WAP4410N Wireless-N Access Point with Power Over Internet 61
6
To manage the configuration for the access point, follow these steps:
STEP 1 Click Administration > Config Management.
STEP 2 To create a backup configuration file, click Save Configuration to File and follow
the on-screen instructions.
STEP 3 To restore the configuration of your access point:
a. Make sure that the configuration file for the access point is on your computer.
b. In the Restore Configuration field, enter the location of the configuration file or
click Browse and locate the configuration file.
c. Click Load.
Configuring Status Settings
This section describes how to change the status settings for the access point:
• “Checking Local Network Status” on page 61
• “Checking the Wireless Status” on page 63
• “Checking System Performance” on page 64
Checking Local Network Status
The Status > Local Network page displays the access point’s current status
information for the local network.

Cisco WAP4410N - Small Business Wireless-N Access Point Specifications

General

Frequency Band	2.4 GHz
Ethernet Port	1 x 10/100 Mbps
Power Over Ethernet (PoE)	Yes
Max Data Rate	300 Mbps
Security Features	WPA2, WPA, WEP
Operating Modes	Access Point
Operating Temperature	0°C to 40°C (32°F to 104°F)
Weight	0.3 kg (0.66 lbs)
Wireless Standard	802.11n