Name: Cisco WAP4410N - Small Business Wireless-N Access Point
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Configuring the WAP4410N Wireless-N Access Point

Administration

WAP4410N Wireless-N Access Point with Power Over Internet 56

Diagnosing Access Point Problems

The Administration > Diagnostics page allows you to use the access point to

perform a ping. The activity can be useful in solving network problems.

To perform a ping test to help diagnose problems with the access point, follow

these steps:

STEP 1 Click Administration > Diagnostics.

STEP 2 Set up the ping test:

• IP or URL Address—Enter the IP address you want to ping. The IP address

can be on your network or on the Internet.

NOTE If the address is on the Internet, and no connection currently exists,

you could get a timeout error. In that case, wait a few seconds and try

again.

• Packet Size—Enter the size of the packet.

• Times to Ping—Select the times to ping from the list.

• Start to Ping—Click this button to start the ping procedure.

Questions and Answers:

Need help?

Do you have a question about the Cisco WAP4410N - Small Business Wireless-N Access Point and is the answer not in the manual?

Cisco WAP4410N - Small Business Wireless-N Access Point Specifications

General