CHAPTER
8-1
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-08
8
Configuring VLANs
This chapter provides these topics about configuring virtual LANs (VLANs):
• Overview, page 8-2
• Management VLANs, page 8-3
• Assigning VLAN Port Membership Modes, page 8-5
• Assigning Static-Access Ports to a VLAN, page 8-7
• Overlapping VLANs and Multi-VLAN Ports, page 8-7
• Using VTP, page 8-9
• VLANs in the VTP Database, page 8-20
• How VLAN Trunks Work, page 8-26
• Configuring 802.1p Class of Service, page 8-31
• Load Sharing Using STP, page 8-32
• How the VMPS Works, page 8-36
Note Certain port features can conflict with one another. Review the “Avoiding Configuration Conflicts”
section on page 9-7 before you change the port settings.
For information about configuring these settings from Cluster Management Suite (CMS), refer to the
online help.
This switch software release is based on Cisco IOS Release 12.0. It has been enhanced to support a set
of features for the Catalyst 2900 XL and Catalyst 3500 XL switches. This chapter provides procedures
for using only the commands that have been created or changed for these switches. The switch command
reference provides complete descriptions of these commands. This guide does not provide Cisco IOS
Release 12.0 commands and information already documented in the Cisco IOS Release 12.0
documentation on Cisco.com.
For information about configuring these settings from Cluster Management Suite (CMS), refer to the
online help.
To Next Page
Loading...
Need help?
General