Contents
v
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-08
Verifying Your Changes 2-34
Change Notification 2-34
Error Checking 2-34
Saving Your Changes 2-34
Using Different Versions of CMS 2-35
Where to Go Next 2-35
CHAPTER
3 Getting Started with the CLI 3-1
Command Usage Basics 3-2
Accessing Command Modes 3-2
Specifying Ports in Interface Configuration Mode 3-4
Abbreviating Commands 3-4
Using the No and Default Forms of Commands 3-5
Redisplaying a Command 3-5
Getting Help 3-5
Command-Line Error Messages 3-6
Accessing the CLI 3-7
Accessing the CLI from a Browser 3-7
Saving Configuration Changes 3-8
Where to Go Next 3-8
CHAPTER
4 General Switch Administration 4-1
Initial Switch Configuration 4-2
Switch Software Releases 4-2
Console Port Access 4-3
HTTP Access to CMS 4-3
Telnet Access to the CLI 4-4
SNMP Network Management Platforms 4-5
Using FTP to Access the MIB Files 4-5
Using SNMP to Access MIB Variables 4-6
Default Settings 4-7
CHAPTER
5 Clustering Switches 5-1
Understanding Switch Clusters 5-2
Command Switch Characteristics 5-3
Standby Command Switch Characteristics 5-3
Candidate Switch and Member Switch Characteristics 5-4
To Next Page
Loading...
Need help?
General