Communication Guide, ©ComAp – March 2014 130
IGS-NT Communication Guide 03-2014.pdf
Bit 15 Invalid configuration format.
Bit 16 Diagnostic codes change (reading resets this bit, only for IL-NT /ID controllers).
Bits 20 Controller type (*)
Bit 21-17 Reserve (= 0)
Bits 22-21 Password level for Setpoints and Commands write (only for IL-NT /ID controllers).
Bit 23 Controller was initiated.
Bits 28-24 Communication module version.
Bits 29 Remote terminal is connected.
Bits 30 Controller type – see the table below.
Bits 31 Reserve (= 0)
(*) Controller type
Hint:
The MODE< and MODE> commands have not been implemented to the register oriented modbus
commands.
Note:
ComAp believes that all information provided herein is correct and reliable and reserves the right to
update at any time. ComAp does not assume any responsibility for its use unless otherwise expressly
undertaken.
To Next Page
Loading...
Need help?
General
