ComAp IS-NTC-BB Reference Guide

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
10
General description
Basic description of COMBI application
The SPtM application is intended for single gen-sets and includes following main features:
 Automatic startup and stop sequences with adjustable timing
 Wide range of generator and engine protections, additional freely configurable protections
 Parallel to the mains operation, many different load control modes (baseload, import/export control
and other)
 Island operation
 Integrated mains protection (mains decoupling relay) including vector shift
 AMF function (automatic start if mains fails) with test feature
 Two breaker control (GCB, MCB) including synchronizing
 Soft loading and unloading
Switching the SPtM, SPI and MINT applications
The default application of IG/IS-NT-Combi is the SPtM application. The SPI and MINT applications can be
activated during the “emergency manual” state only.
To change the application from the SPtM to SPI application close both BI: Emerg. manual and BI: SPI
Enable and after that open BI: Emerg. manual only. The controller is set to SPI application now.
To change the application from the SPtM to MINT application close both BI: Emerg. manual and BI:
MultipleEnable and after that open BI: Emerg. manual only. The controller is set to MINT application now.
To change the application from either SPI or MINT to the default SPtM application close the BI: Emerg.
manual and open either BI: SPI Enable or BI: MultipleEnable. After that open the BI: Emerg. manual. The
controller is set to SPtM application now.

ComAp IS-NTC-BB Specifications

General

Brand	ComAp
Model	IS-NTC-BB
Category	Controller
Language	English