ComAp IS-NTC-BB Reference Guide

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
57
NOTE:
Masking of screens in InteliVision 5 supports only Show function
Use also other masking functions (masking can react on several internal states, e.g. activation of Timers).
PLC functions
See description in IGS-NT-Application Guide 05-2013.pdf.
Multi language support
NT family controllers support up to five Languages that is possible to switch during controller duty. Every
terminal (i.e. Remote display or PC-InteliMonitor) can be switched to different language. Use PC-GenConfig
- Translator tool to translate texts to another language.
Default application archives contain all texts in English only.
ECU interface customizing
The list of available ECU interfaces can be found in GenConfig / Modules / ECU list.
Binary selector
This function enables to change the following CAN values transmitted to ECU via J1939 or binary output
only. The change can be provided by setpoint or via Binary input. There are four Bin selector channels
available.
J1939 value
ECU command
Governor mode
Isochronous - Droop
Idle Speed select
Idle – Nominal
Frequency select
1500 – 1800
Preheat request
Yes – No
Protection override
Yes – No
Engine params: Bin selector x
Bin selector x
CAN - J1939
Force value: Force value y
Force value y

ComAp IS-NTC-BB Specifications

General

Brand	ComAp
Model	IS-NTC-BB
Category	Controller
Language	English