5–8 Hardware Guide
Drives
2. Select the Advanced menu > Device Options.
❏ To enable bootable media in USB drives, select Enable
USB legacy support.
❏ To enable an internal NIC, select Internal Network
adapter boot.
3. To save your preferences and exit Device Options, press
F10.
4. To close Computer Setup and restart the computer, select
File > Save Changes and Exit, then press
F10.
✎
To connect a computer with an internal NIC to a PXE or RPL
server during startup without using MultiBoot (whether or not
MultiBoot or USB legacy support are enabled), press
F12 when
the Network Service Boot message appears briefly in the
lower-right corner of the screen.
Using the Default Search Sequence
By default, MultiBoot is disabled and the computer selects the
startup medium or device by searching enabled locations in the
following sequence.
The following list describes the order in which drive numbers are
assigned. The actual startup sequence will vary by configuration.
For example, the computer searches only once for a device
containing a medium that can boot as drive A. If the first device it
searches does not contain a medium that can boot as drive A, the
computer begins a single search for a device containing a medium
that can boot as drive C.
To Next Page
Loading...
Need help?
General