DES-3226S Layer 2 Fast Ethernet Switch User’s Guide
43
Click the Save Configuration button to save the current Switch configuration in NV-RAM. The following dialog box will
confirm that the configuration has been saved:
Figure 6 - 5. Save Configuration Confirmation
Click the OK button to continue.
Once the Switch configuration settings have been saved to NV-RAM, they become the default settings for the Switch. These
settings will be used every time the Switch is rebooted.
Factory Reset
The Factory Reset function has several options when resetting the Switch. Some of the current configuration parameters can
be retained while resetting all other configuration parameters to their factory defaults.
NOTE: Only the Reset System option will enter the factory default parameters into the Switch’s non-
volatile RAM, and then restart the Switch. All other options enter the factory defaults into the current
configuration, but do not save this configuration. Reset System will return the Switch’s configuration
to the state it was when it left the factory.
Reset gives the option of retaining the Switch’s User Accounts and History Log while resetting all other configuration
parameters to their factory defaults. If the Switch is reset with this option enabled, and Save Changes is not executed, the
Switch will return to the last saved configuration when rebooted.
The Reset Config option will reset all of the Switch’s configuration parameters to their factory defaults, without saving these
default values to the Switch’s non-volatile RAM. If the Switch is reset with this option enabled, and Save Changes is not
executed, the Switch will return to the last saved configuration when rebooted.
In addition, the Reset System option is added to reset all configuration parameters to their factory defaults, save these
parameters to the Switch’s non-volatile RAM, and then restart the Switch. This option is equivalent to Reset Config (above)
followed by Save Changes.
Figure 6 - 6. Factory Reset Screen
Click the Apply button to reset the Switch.
To Next Page
Loading...
Need help?
General