DGS-1510 Series Gigabit Ethernet SmartPro Switch Hardware Installation Guide
33
Connecting to the Switch for the First Time
After successfully connecting to the Switch’s console and the Switch was turned on, the boot-up
procedure will be displayed, as shown below.
Boot Procedure V1.00.015
-------------------------------------------------------------------------------
Power On Self Test ........................................ 100 %
MAC Address : 3C-1E-04-A1-B9-E0
H/W Version : A1
Please Wait, Loading V1.50.020 Runtime Image .............. 100 %
UART init ................................................. 100 %
Starting runtime image
Device Discovery .......................................... 100 %
Configuration init ........................................ 100 %
Switch con0 is now available
Press any key to login...
During the boot-up procedure, we can find the PROM version, MAC address, hardware version, and
firmware version used by this Switch.
NOTE: Both the default username and password is admin.
Enter the username and password when prompt to do so and press enter after each entry. The CLI
prompt will immediately be available, as shown below.
DGS-1510-28XMP Gigabit Ethernet SmartPro Switch
Command Line Interface
Firmware: Build 1.50.020
Copyright(C) 2018 D-Link Corporation. All rights reserved.
User Access Verification
Username:admin
Password:*****
Switch#
Now the Switch can be configured.
To Next Page
Loading...
Need help?
General