DGS-1510 Series Gigabit Ethernet SmartPro Switch Hardware Installation Guide
34
CAUTION: For security reasons, it is highly recommended to configure a personal
username and password for this Switch.
Creating a User Account
This section will discuss how to create a login username and password on this Switch. This login
details will be applied not only for access to the CLI, but also for access to the Web UI, Telnet, SSH,
and SSL interfaces. The same username and password will be used for these connections.
To create a user account, enter the following commands.
Switch> enable
Switch# configure terminal
Switch(config)# username Administrator password 12345
Switch(config)# username Administrator privilege 15
Switch(config)# line console
Switch(config-line)# login local
Switch(config-line)#
In the above example,
• We accessed the Privileged EXEC Mode by entering the command enable.
• Then we entered the Global Configuration Mode by entering the command configure
terminal.
• Then we created a user account with the username of ‘Administrator’ and gave it the
password of ‘12345’ by entering the command username Administrator password 12345.
• Then we assigned the privilege level of 15 to this user account by entering the command
username Administrator privilege 15. The highest level access is 15 and the lowest level
access is 1.
• Then we entered the LINE Configuration Mode by entering the command line console.
• Then we configured the Switch to allow access to the management interface by using locally
configured user accounts. The command is login local.
NOTE: CLI configuration commands only modifying the running configuration file and are
not saved when the Switch is rebooted. To save all your configuration changes in
non-volatile storage, you must use the copy running-configuration start-up-
configuration command to copy the running configuration file to the start-up
configuration. For more information, refer to the CLI Reference Guide.
Configuring the IP Address
Each networking node, within a network, must use a unique IP Address. This IP address is used to
communicate with other networking devices in the network. The IP address of the Switch is also
important to be able to access the Web UI of this Switch.
There are two methods a Switch can obtain an IP address.
• The Switch can obtain an IP address from a DHCP server located within the local network. By
default, this option is not enabled.
• The administrator can manually configure an IP address for this Switch.
To Next Page
Loading...
Need help?
General